Just bought a clean 2004 C70 with 110k miles. The tranny slips and downshifts hard when hot. CEL is on and reading codes p0740 and p0785. OD arrow is also flashing. Anyone know what could cause this. Im hoping to not have to replace the transmission. Any help would be appreciated. Thanks!

yes two o rings and a new solenoid

Thanks for the info, Mine is an automatic, is it a similar rebuild? I couldn't load the automatic section from that manual.

I just bought a 1991 240 and it has no overdrive. The fuse is good, the relay is good and I am getting voltage to the solenoid. I replaced the solenoid because the rubber on the top of it was all rotted and breaking. With the new solenoid installed I still have no overdrive.....Does anyone have any ...

I am having trouble with a friends car that I am working on. It is stalling and running pretty rough. I am getting codes p0456, p0442 p1238, and its running rich. I replaced the turbo control valve and inspected all vacuum lines but it still has the same symptoms. Im not sure where to go next, any h...

Yes I did as much research as I could before posting. But none of that discussion helped. I am trying to get voltage to the air pump. The relay and fuses are good. Pump works when jumped... Will there only be voltage on start up? Thanks

Hey I have a 1997 960 that is throwing the p0410 code. I checked all the fuses and relays and they are all fine. However the pump itself is not getting voltage....It will work if i jump it directly from the battery. Can anyone help me as to where the next place I should look? thanks.

what size engine, year make and model? I can look it up on all data.

I have a 95 960 that stalls when it gets hot or normal operating temp. It feels like its out of gas but tank is full. i sometimes smell gas. It wont start again until its cool, then stall out when at temp. I ran the codes and one was a coolant temp sensor, so i replaced it and same problem. I erased...

Make sure that the cam position and crank position wires (2 big fat insulated ones coming from the sensors) are as far away from each other as possible - zip-tie them if you can. They'll cause interference with each other and codes and/or bad running if they get too close to each other.[/quote] Ok i...