Dos, sorry about the delayed response. It is a double wall construction so the magnet trick might not work. I thinks I leveled a a piece of wood across top of fender and measured down. Then drilled a small pilot hole. Don't really remember unfortunately. Used a 1.5 inch hole saw. Could've been small...

Those sneeky cam pulleys like to move, especially the exhaust cam. They are difficult to move by hand so I didn't think they would budge but they did and I had to remove the belt. I cut a 2x4 and gently wedged it between the cams. Maybe I'll get the IPD holder for next time Running perfectly now, n...

If anyone finds themselves in a similar situation, here's a picture of the tension pulley as viewed through the hole in the wheel well. Fairly straight forward. Plugged hole with rubber grommet and caulk.

Brilliant. Thank you, Sam

Had to drill a hole through the wheel well then pound in a torx 47 using mallet and socket extension. Provided enough bite to loosen the torx bolt and remove tension pulley. Now got to figure out easiest way to plug the whole.

Yes, like many before me, I've stripped the idler tension pulley torx bolt. Tried everything short of hole in wheel well or Dremel. Am in Berkeley and need some guidance. Thanks in advance.