What bearing kit did you get? National Bearings RA-338 I was mistaken about FCP, I checked my order history and turns out they both came from Autozone, only one I bought in person and one I ordered online. AZ part number RW131R The national bearing part number doesn't appear to have the rings. I wo...

Can you use the above mentioned slide hammer to install the axles? I could. but I don't think it's necessary. I went to the junkyard today, pulled an axle and measured the ring and bearing. The axle pushed right back in by hand, no problem. The ring I have is about 5mm wider than the one on the jun...

I can see the end of the driver side shaft inside of the spider gear, so it is sliding into the spider gear fine. The only thing I can think is that the bearings are too wide. They only had one bearing in stock at autozone, I ordered the other one from fcperuo, I would surely hope one would be corre...

Nope, no c clips, I have the diff cover off. The axle is kept in the vehicle by the press fit of the bearing and spacer, which is in turn held into the axle tube by the flange and bolts. Really it should have no trouble sliding in, it didn't take much at all to pull it with the silde hammer and it w...

I pulled both axle shafts and replaced the bearings. They came out pretty easily with a slide hammer. I pressed on new bearings and replaced the seals. Now I can't get the darn things back in again. They go almost all the way, I only need about another 3/8" I tried using the flange and bolts to...

I found that, but their web based pdf reader is miserable, and there is no way that I can see to download them. I did find this site, and if you use the google translation, it's actually fairly readable.

http://www.240.se/

Thank you!

k jet has gone down and the domain has expired. Does anyone have these pdf files? I should have downloaded them when I had the chance. I have the fault tracing greenbook TP31361-1, if anyone needs it.

The girl took the car to a shop, they said it was a bad pnp switch. FCP accepted the return and issued refund.

I noticed one of the brackets that holds the rear bumper to the impact absorbers has rotted away pretty bad. Before I go and fabricate new ones, does anyone have any they would sell me? Thanks

Awesome, thanks!