All -

Does anyone have a REM diagram for a 2002 Volvo S60 AWD 2.4T.
I have a "check brake light" warning message it it's not the bulb.
I suspect the relay is bad or the REM is going bad.

All - My passenger side tail light is not working. The bulbs are good so there must be something in the wiring. Does someone has a diagram that shows the wiring for the passenger tail lights? BTW: The computer does not indicate a bulb failure or any other issues with the rear lights. Thx in advance

UPDATE:

I replaced the canister purge valve and the Check Engine Light no longer illuminates and there are no OBD II Codes.

A $60 part and 20 minutes to replace looks is all it took to fix.

Thanks for everyone's help.

//Kevin

I pulled the EVAP canister purge valve and hooked it up to a fresh 9V DC battery. There is no clicking when I applied the 9Vs to the purge valve. I assume this means the valve is stuck. I can't blow through the valve so I assume that if it is stuck, it is stuck in the closed position. Does this conc...

All - For those interested, I completed the repair over the weekend. The removal and replacement of the washer fill sensor was much easier than expected and did not require the removal of the washer bottle. I used ramps under the front tires so that I had room to get under the front passenger side o...

Thx. Since my bottle is fine and all I need to do is replace the washer level sensor I am hoping that I can just pull out the sensor while the bottle in in place and stick the new one in. I can easily get access to the bottom of the bottle to access the sensor. I am just not sure how the sensor is h...

All - I need to replace the washer sensor because the ground wire broke at the hardness and the wire cannot be reconnect to the existing harness. The hardness, sensor and power to the washer pump are all a single connected part. Does anyone know how (or ideally have instructions to) remove the exist...

Did you remove the ground connection from the battery before removing the radio?

This can cause the SRS message to appear. This message can be cleared by someone who has a Volvo scanner. I cannot be cleared using a generic OBDII scanner.

//Kevin

Did he check the relay?

Did you check fuse #7 in the engine compartment fuse box and fuse #34 in the CEM fuse box? Did you check relay FST3 in the engine compartment fuse box. While at it check FST2 as well. Do the headlamp wipers work? Here is the wiring diagram. Page 79 has the diagram for the washer. http://www.volvowir...