960 3ltr 1994 rear coil spring replacement

father ted · Post by **father ted** » 06 Feb 2010, 04:01

Haveing aquired new rear coil springs for my multilink suspension fitted 960 i am now wondering if there are any pitfalls to look out for during fitting. Can i lift the whole back end up and fit them both together or one side at a time. I am aware of the brake pipes restricting movement but is there anything else i should be aware of. Any help is appreciated.

Post by **billofdurham** » 06 Feb 2010, 11:47

The attached should help. You can do both sides together but note the part about disconnecting the drive shaft.

960 rear coil springs1.pdf: (217.52 KiB) Downloaded 125 times

Bill.

father ted · Post by **father ted** » 07 Feb 2010, 03:25

Thanks Bill, spot on! everything i needed to know.