Fuel pump assembly not in correct position.

whitebulldog73 · Post by **whitebulldog73** » 17 Mar 2012, 17:20

Hello MVS,

I noticed that my fuel gauge isn't reading my fuel level correctly. Recently i removed the fuel pump assembly to siphon some gas out. Apperently, I didn't put it in the correct position to properly read the fuel level. Now with that said, i seen a mark on the top of the pump assembly. Should that point a certain way, or is there other way or other markings to properly read the fuel level.

Any help or advice would work.....Thank you all.

Sincerely;
novice backyard mechanic.

Post by **billofdurham** » 18 Mar 2012, 12:15

Two marks on the pump should align with two marks on the tank:

: untitled.JPG (19.88 KiB) Viewed 340 times

Bill.

whitebulldog73 · Post by **whitebulldog73** » 19 Mar 2012, 13:39

Thank you sooo much, thats what i thought cause with close examination, i seen the markings.....well this confirms it...thank you sooo much again bill.

Sincerely;
Jon in '96 960