Tensioner Roller

Post by **erikv11** » 22 Dec 2015, 13:30

OP has a yellow, he doesn't want to drill a hole, I empathize ..

jcdillin · Post by **jcdillin** » 22 Dec 2015, 14:46

Know anyone with a welder? May be quicker to just weld a stubby bolt onto the end of the torx bolt.

Post by **cn90** » 22 Dec 2015, 15:49

Couple things, the dremel is OK but slow. An Angle Grinder is better.
If you own an Angle Grinder with diamond blade it is much quicker.
It is $25 at Menards hardware store:
https://www.menards.com/main/tools-hard ... c-9075.htm

You will need to cut diagonally like this:

: TB.jpg (44.28 KiB) Viewed 1248 times

Post by **erikv11** » 22 Dec 2015, 16:38

Great pic. Then take it down to the foundry and melt it, be sure you get to watch it go.

Post by **rspi** » 22 Dec 2015, 19:44

I have experienced this nightmare a couple of times. Both times, I left the bracket alone, pulled the roller off, installed the new roller, tapped the end thread, and walked away. I have checked them many times and the cars have gone over 50,000 miles since. The screws are probably torqued to 10 ft lbs instead of 18 but hey, it has worked for me.

FastYellow · Post by **FastYellow** » 22 Dec 2015, 22:07

Its a painstaking process but i know i will get it out.
Thank you all for the awesome input. I will try the angle grinder approach great pics.
The dremel is slow although the carbide bits help i need a bit more cutting power.
Once again thanks all.
I will post my progress.

FastYellow · Post by **FastYellow** » 22 Dec 2015, 22:10

I wanted to replace just the roller. I have a brand new tensioner roller....but the stuborn head in me went dremel happy. I kinda wish now i would have done what Rober suggest. I hope its all for the best of my yellow

Post by **rspi** » 23 Dec 2015, 03:55

I have read in places that some people had success with getting it off by putting vice grips on the metal ring.

Tensioner Roller

Re: Tensioner Roller