1999 Volvo S80; Head Gasket Question

Help, Advice, Owners' Discussion and DIY Tutorials on the Volvo S80 model. Sometimes called an "executive car", the S80 was and continues to be Volvo's top-of-the-line passenger car.
Post Reply
jacobcag
Posts: 9
Joined: Wed Jan 31, 2018 5:42 pm
Year and Model: 1999 S80
Location: Virginia
Has thanked: 1 time

1999 Volvo S80; Head Gasket Question

Post by jacobcag »

Hello Fellow Volvo Amigos,

Long story short, my dumba$$ broke the coolant pump pipe bolt that runs into the back of the cylinder head. My question is whether I need to purchase another head gasket. I've torqued down the cylinder head (40nm) but didn't tighten it to the angle (130 degrees). What I'm not sure about is whether the gasket has been formed to the block yet, since A I didn't run it at all and B It wasn't torqued to the degree (not sure how much more force that applies to the bolts). This may seem like a dumb question to some but if I can reuse the gasket I'd like to.

I'll be posting some pictures of it tomorrow once I take off the head. Thanks in advance to anyone who responds.

User avatar
SuperHerman
Posts: 1674
Joined: Mon Dec 01, 2014 1:28 pm
Year and Model: 2004 & 2016 XC90
Location: Minnesota
Been thanked: 178 times

Post by SuperHerman »

That is a tough one. If I recall the hg is MLS. It is not an expensive part if one wants to be safe.

That said I have reused hgs in similar situations as you are in and have not had a problem. Specifically no oil added, no heat and when I removed the head the hg did not have any material come off it.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post