Did you know? 🤔
Logged in users can get email notification of topic replies Log in or register (free).
Amazon Link Buy your stuff using this and it helps MVS!

Headlight washer/spray fault

Help, Advice and DIY Tutorials on Volvo's extremely popular car line -- Volvo's 1990s "bread and butter" cars -- powered by the ubiquitous and durable Volvo inline 5-cylinder engine.

1992 - 1997 850, 850 R, 850 T5-R, 850 T5, 850 GLT
1997 - 2000 S70, S70 AWD
1997 - 2000 V70, V70 AWD
1997 - 2000 V70-XC
1997 - 2004 C70

BlueRubber
Posts: 5
Joined: Fri Jan 26, 2018 4:27 am
Year and Model: v70 2002
Location: Reading, UK
Has thanked: 4 times
Been thanked: 0
Great Britain
BlueRubber

Headlight washer/spray fault

Post by BlueRubber » Mon Feb 11, 2019 9:27 am

Car: 2002 v70

On the left hand side of the car the headlight spray doesn’t spray any fluid, the right hand side does.
I cannot see any dripping under the car or around the engine bay to indicate a leak.

Any suggestions on where I should look for the fault?

Neither headlight wipers work, but I think I need to remove the front bumper to fix this so will leave this for warmer weather.



scot850
Posts: 5497
Joined: Mon Apr 05, 2010 2:46 pm
Year and Model: 2000 V70 R
Location: Calgary, Alberta, Canada
Has thanked: 6 times
Been thanked: 135 times
Canada
scot850

Re: Headlight washer/spray fault

Post by scot850 » Mon Feb 11, 2019 12:23 pm

The 2002 is different to our 2006 XC70. It does not have the wipers but just a pressure jet. The system did not work. Had t oremove the bumper to investigate. Found the pump had exploded (like an Alien stomach exit!!). Have to guess someone had left non-winter windshield washer fluid in when it gets cold here (-30C or below in winter). Replaced the pump and all was then good.

If you have the older wiper motor and arms then they have their own issues. Not seen the earlier P2 model version to see how similar they are to the P80 versions. If they are chances are they suffer the same issues of the overload resistor failing internally in the motor housing. While I don't know anyone who has found a supplier of the flat square resistors, most replace them with a piece of copper wire. I would then recommend replacing a fuse option between the motor and the fusebox to prevent blowing anything else if they overload. Reasons for that would be if they freeze in winter.

Neil.
These users thanked the author scot850 for the post:
BlueRubber


2000 V70 R - still being an endless PITA
2006 XC70
2003 Toyota 4Runner V8 Limited
2015 Kia Sportage EX-L
1993 850 GLT -Sold
1998 V70 XC - Sold
1997 Volvo 850 SE NA - Went to niece in California - Sold
2000 V70 SE NA - New project and test bed - Sold

Post Reply