1999 s70 t5 banjo bolt which hole?

i4gotmyid · Post by **i4gotmyid** » 27 Nov 2023, 16:26

So...i'm an idiot, I removed the pcv breather hose (without photos) and am ready to reinstall it. I noticed there are two such holes to install it in, a lower and upper. The slotted guard on the hose seems to suggest the higher one, but there are marks on the lower that indicate the hose was previously there. If I try to put the hose on the lower, the guard pushes the hose away from making contact. I figured I would ask here and see as I dont want to have to do this twice and I dont have access to an already built engine.

1999 S70 Turbo ch-00353
Part # for hose 9470330

: PXL_20231127_193300731.jpg (249.71 KiB) Viewed 320 times

Post by **abscate** » 28 Nov 2023, 02:23

This is the coolant banjo off the PCV manifold that mounts on the rear of the cylinder head? I’ll snap a pic this morning

i4gotmyid · Post by **i4gotmyid** » 28 Nov 2023, 07:57

Yes! I would so appreciate that!

Post by **abscate** » 28 Nov 2023, 08:54

Well, not sure if picture helps. Let me try to scour archives , too.

rrres · Post by **rrres** » 28 Nov 2023, 14:01

: banjo bolt.jpg (209.99 KiB) Viewed 263 times

: Flywheel Housing Port after removal of Crank position sensor and housing.jpg (506.49 KiB) Viewed 263 times

The one with the coolant.

: IMG_0707.JPG (383.57 KiB) Viewed 263 times

Post by **abscate** » 28 Nov 2023, 14:37

It looks like the banjo threads into the head and the heater hose right below it into the block?

Post by **scot850** » 28 Nov 2023, 14:55

I just checked also, but it is hard to see on a built up motor with the turbo. However, mine is plugged into the lower hole as Abscate says.

Neil.

i4gotmyid · Post by **i4gotmyid** » 28 Nov 2023, 16:02

Thanks guys! Moving forward makes me feel accomplished