Timing and code issue 2001 V70 2.4t

jshwhite · Post by **jshwhite** » 11 May 2009, 07:01

I have a 2001 V70 2.4t. I have had a check engine light on for a while. I scanned it and it read "P0014 Cam position actuator B-Bnk 1 Timing over advance." I have cleared the code a few times and it always comes back after just a little while. I did some research and it seems like everyone who had this problem found that it was a timing belt off a little. Yep, that's me. I changed the timing belt a while back. I thought I got it right on, but I must not have. The car has also been a bit sluggish after I replaced it, so that really seems to indicate that that's the problem. Now my question is, how do I set it correctly? Is there somewhat of a procedure I can go through to get it correct? Any help or diagrams would be greatly appreciated.

Thanks,
Josh

Post by **vegasjetskier** » 11 May 2009, 08:19

Go to this thread and on page 2 scroll down about 1/2 way. There are 10 scans of the Haynes manual that tell you how to do the work and make your own locking tools.

https://www.matthewsvolvosite.com/forums ... a&start=14

jshwhite · Post by **jshwhite** » 11 May 2009, 08:44

Thanks so much. It looks like that should help a lot. I'll probably do it this afternoon, and I'll let you know if it fixes the problem.

Thanks again,
Josh

jshwhite · Post by **jshwhite** » 12 May 2009, 17:54

OK, I just finished it. The belt was a tooth off. I corrected that and checked and re-checked everything. Runs like a top now. The check-engine and service lights are off and the engine is not sluggish at all - runs like a different car.

As always, this is such a great site! Thanks so much to everybody! Keep up the good work!
Josh

Post by **MadeInJapan** » 12 May 2009, 18:05

Another satisfied customer!