Bulb Failure Position Light Topic is solved

mfmcadams · Post by **mfmcadams** » 28 Sep 2017, 11:13

Is rhere a trick to getting that upper back running light out? It is hard to reach and harder to see.

Post by **volvolugnut** » 15 Dec 2019, 17:54

Small hands and cursing. Remember the position coming out will make replacing a little easier. But not much.
volvolugnut

sxu · Post by **sxu** » 13 Dec 2020, 15:19

I have this message for a months. I checked all the and they all work. But the message is still there. Any suggestions?

Post by **volvolugnut** » 26 Jan 2023, 16:06

After several years of intermittent "Bulb Failure - Position Light" warnings, I think I may have found the solution. The bulb holders had the contacts bent too far in and did not make good contact all of the time. I recently bent the contacts out (away from the bulb) sightly and have not had the warning for several days. Previously, a bump or just starting on a new drive would turn off the bulb and display the dash warning.
volvolugnut