Maybe drill a hole ( 5-8mm ) off to the side in each drawer handle and drop a steel rod down through them. That would connect them all together and that alone might hold them in place. If not, then it wouldn't be hard to figure out a way to attach that rod to the cabinet while moving it around. I'm ...

^ Then throw them back in the lake where they apparently came from. Seriously, I just can't believe the amount of rusted parts that I have seen posted here. I wish there was a way for a NE group buy of some sort to get replacement parts from this part of the country over to you guys in the rust zone...

I nice one for the RWD crowd.
https://tucson.craigslist.org/cto/d/tuc ... 07192.html

I vote for a MVS group buy on lifts .....and beer

I would say " Yes ". That little o-ring needs to be replaced. Tad bit easier than splitting the block.

Replaced heater hoses with IPD silicone ones.

The japanifold offers the best flow of them all. So japanifold is the performance alternative? Although the short length may not make much difference. volvolugnut Yes. From what I've read there's also a difference in the internal runners as well as in the metallurgy to prevent that cracking. What I...

Nail history and collection: When I first got into the building trade almost 50 years ago now, it was said that a carpenter drove more nails in one day than the average person would drive in a lifetime. And looking at some of these framing nails, you can imagine the " guns " needed to spen...

Holiday season. He's got pi on the mind.

^
Well we know he does get a bit pi-eyed over Nautic Blue 99V70's.
But I think I'm straying from the OP's lock problem. Unless it's jammed up due to......