Closing the story on this issue now. I bought a generic receptacle with pig tails from the local parts store, then took off front bumper cover to remove headlight assembly so wiring could be done indoors with sufficient space. After reassembly bulb lights, so I will button up the bumper cover tomor...

I am stumped by a strange door locking response on 2001 V70. I recently had the drivers door card off to fix the detached outside opening handle rod. I disconnected all of the electrical connections during this process. I tried to get the two push/pull rods back in the clips at the same length. Eve...

don't start adjusting anything before trying a disconnect and soft reboot of the computer.

Disconnect battery for a while to let it bleed off surface v.
Put the key in position II, reconnect the battery.

I ordered a balljoint. I'll replace that and see how it behaves. I'm more curious to see if that solves the issue than anything else. Thank you! it looks like one of the balljoint bolts snapped , and the other isn't far behind. I went through that last summer, welded a nut to the broken remnant to ...

burp the system by squeezing the top hose, drive around the block and top the level up before it gets hot. run the heat to make sure you're getting circulation. At least get a torque android phone app so you can see what the actual coolant temp is. I use this one, Its pretty slick for $10. https://w...

I unplugged my siren 3 yra ago, sunroof still works, but I never use it .
Not sure if I unplugged the siren or just removed the battery. Either way, I still get one without the other.

If the new good cap will not help, you have a blown gasket or a crack in cylinder. I sure hope it's not that :0 But, I think it was just an air bubble in the system. I didn't flush the cooling system after installing the radiator. Whenever I do cooling system work, I'll get the low coolant warning ...

Step 1. Install a lift.

it can be done, it helps if you have girlyman arms with universal jointed elbows. Its usually the gasket at the top which leaks, gasket shellac glue the new gasket to cleaned pipe flange for easier positioning. Make sure the old O ring seal at the bottom of the pipe comes out. a coolant pipe is held...

strongly suggest installing a new axle bolt to spec, mine departed after reusing it. Pry bar with a short length of chain over the control arm is an easy way to pull it down. Loosen the control arm bolts to allow more freedom of movement. or get this $15 OTC tool. https://youtube.com/shorts/Yz0K8BX2...