Search found 362 matches
- 16 Mar 2021, 11:40
- Jump to forum
- Jump to topic
Re: 1997 v70 T5 Stutter at WOT on T5
So quick question: If I'm set up with M4.4 but have a FPR on the rail, what should my pressure be ? 35psi at idle ? If so then I'm getting a little too much pressure myself. Now back to Fiodor's problem... Yes...if FPR is stock. With factory setup,M4.4 cars have constant 43.5psi fuel pressure no ma...
- 02 Apr 2021, 01:50
- Jump to forum
- Jump to topic
Re: TIMING MARKS OKAY ?
It's not ok.
Crank is one tooth off.
Turn in back on the mark and install the belt.
Pull the pin from tensioner,rotate the crank for few revolutions by hand and recheck again.
If everything is on marks,you are done.
Crank is one tooth off.
Turn in back on the mark and install the belt.
Pull the pin from tensioner,rotate the crank for few revolutions by hand and recheck again.
If everything is on marks,you are done.
- 07 Apr 2021, 16:40
- Jump to forum
- Jump to topic
Re: MAf sensor, Bosch NLA
Clemens....find Bosch car service in Austria or Germany. It's authorised Bosch dealer(service). Bosch 0 280 217 107 is still available in EU brand new. Their price is around 250€. The same OE part in Bosch yellow & red box and you don't pay double price for blue Volvo box. Bremi is NOT and will ...
- 08 Apr 2021, 01:39
- Jump to forum
- Jump to topic
Re: MAf sensor, Bosch NLA
Bosch Car Service for all Bosch parts and sensors!
Excellent prices,compared with Volvo blue box parts prices.
Same parts,but without ridiculous high Volvo blue box prices.
Excellent prices,compared with Volvo blue box parts prices.
Same parts,but without ridiculous high Volvo blue box prices.
- 11 Apr 2021, 12:35
- Jump to forum
- Jump to topic
Re: MAf sensor, Bosch NLA
So what is the problem with the Bremi's MAF, or more specifically, how do they not work ? I have one that I didn't end up needing, so it's just sitting in its box. I can't see FCP taking it back " just because ", so I figure I'll keep it for testing purposes. But I am curious as to what m...
- 13 Apr 2021, 08:05
- Jump to forum
- Jump to topic
Re: Is radiator fan remains ON normal after engine is OFF
If you flushed it...you ruined it.
- 14 Apr 2021, 15:18
- Jump to forum
- Jump to topic
Re: 850 ECC troubleshooting
You will need to transfer the plastic propeller and plastic casing to new motor. For pulling the plastic propeller(blower) you will need a puller tool. After it's removed...just lightly tap it onto the new motor shaft and be careful not to damage the new motor. Press in the blower onto the new motor...
- 14 Apr 2021, 16:43
- Jump to forum
- Jump to topic
Re: 98 v70 n/a vs 95 850 turbo parts swap, 96 960 remote
Dashboard...no...because of different shaped windshield and door cards on 70 series. Headlights and trim and corner lights..no....because of different shaped cross member,fenders and bumper on 70 series. Door trims ...outside door trims? Foglights....no....different shaped bumper on 70 series. Remot...
- 17 Apr 2021, 11:32
- Jump to forum
- Jump to topic
Re: Installing V70 D-pillar speakers in 850 wagon?
Mine is prewired for D-pillar speakers and speaker wiring are connected with cd-player....tried it and speakers work but i have a problem to find original speakers with their original mountings to fit them.
Speakers from '99 will work fine in your 850.
Speakers from '99 will work fine in your 850.
- 21 Apr 2021, 12:20
- Jump to forum
- Jump to topic
Re: 95 Volvo 850 Turbo won't start
If you were lucky,you didn't fried ecu and other modules.
In rare cases some people got away with fried alternator,battery and some relays under fuse box.
It would be a miracle if you didn't damaged electric system on jumper car...too.
Not fun.
In rare cases some people got away with fried alternator,battery and some relays under fuse box.
It would be a miracle if you didn't damaged electric system on jumper car...too.
Not fun.






