wasn't there an easy method to measure the exhaust temp before and after the cat with an IR Thermometer? if the difference is too high, the cat is blocked.

matthew1 wrote: ↑28 Oct 2024, 17:27
Yep, same with looking for shorts to block ground in plug wires.

Dark is not much help on coil over plug machines. Old tricks are getting tired.

volvolugnut

Nice! I haven’t tried a Segway but I believe it’s similar technology to the onewheel. Very important to buy all the safety equipment available including pads and wrist guards etc. a full face MTB helmet is a good idea also. I put 27 kilometers on my onewheel on Friday and the only thing that hurt af...

Ok. Install was successful. I can confirm this (Mazda 3) specific shock fits the V50 perfectly. I moved over the top metal 3/4” spacer bracket that the AWD only model uses. As a note: you need to turn the normal correct bearing position on the top of the replacement shock 180 degrees around because ...

matthew1 wrote: ↑01 Nov 2024, 13:35 This looks like the car the Italian had, yes. It was for sure a Maserati, like Joe Walsh drove... or rather didn't drive, back in his day.

He had a limo, rode in the back.

Does your car have a "memory" driver's seat with the "1, 2, 3" buttons? If so, this is likely the same "memory" system trying to adjust the mirrors, and getting confused. Adjust them where you want them, adjust the seat, press and hold "mem", and then press &q...

Morning, since the Flu got me, i have some time on my hands... what is saw, the ECM switches from Open loop to closed loop everytime the rpm drops... i will try to make a video from live data, just need to wait a bit, not everyone here loves 5cyl revs in the morning :) The car should remain in clos...

I have figured it out, it's dark every day I get home and I have to work by shoddy lights but I found plastic tabs holding a circuit board in place. Remove that board and the lamps are easy to remove! You can see photos in this german forum https://volvo.reparaturanleitung.info/volvo/index.php?threa...

It would be a challenge to ship, but if anyone needs the C70 sub-frame brace pair I have a set. I got them for the R before discovering you can't fit them to an AWD P80 due to the prop-shaft center support bearing using the mounting holes the main brace uses.

Neil.

Moin,

so the culprit was the TBM, changed it to a Bosch Unit (0 280 750 131), adapt it with VIDA and after short warming up, the engine stayed at one RPM in the Range for TÜV.

Thanks for the Help! Good thing i found this place.

Regards - Alex