Hello, almost 2years ago when my 07 v70 2.5t was hit by a drunk driver while parked at the curb, rear left door caved in and flat tire, toe in approximately10degrees IMG_1700.jpeg .installed the doughnut wheel on and eyeballing rear wheel alignment. Next day removed the wheel and inspected the suspe...

Your car is too beautiful to scrap . Hopefully you have alternative transportation during a rebuild. have them rebuild it with a valve you got from a dismantler (or from MVS!) Are new valves so hard to obtain that used and Skandix are our only options? What does a machine shop do during a head rebu...

I'd want him out of there too!

Last time I went down this rabbit hole I think I had the belt off and on 12 times before I got it right. Documented it inthe Elizabeth maintenance thread. I know this is an old thread but I'm having similar issues on an 06 v70 2.5t and would like to read through that Elizabeth thread, can someone p...

Probably the old, failed pump from 2022 was pulling high current and old connections were oxidized, so the copper got dirty. New splices and the Kat is purring again. What kind of car runs you around town, then does a not start in your driveway and still gives you time to catch your train? A puuuur...

A rear bumper bracket and bracket bolt?

Driver's/left

In the first week of May, i went to the Tulsa LKQ to get the dolby CPU mount, dash, and wires. I took the sc901 too. I was confused why I could not find the amp under seat or in tunnel. After I removed the airbag from the dash panel, I forgot to grab those wires off of the seat. Last Saturday, I wen...

This has been posted about extensively the last few years but to recap here: Factory P80 calipers have nearly immortal (!) stainless steel slide pins. On even the most rusted, shot factory calipers the slide pins are usually fine, probably could use a de-greasing and light sanding (and re-greasing w...