Figured it out

Cruise control vacuum pump

Mounting to/under battery tray through a slot and secures with a screw (missing)

"Where to hook up smoke machine?" Many responses and not many suggestions where to connect the smoke machine - I was looking for this info as well. I connected the smoke machine to the lower hose of the EVAP valve located atop the radiator fan, into the hose that comes up along the radiato...

I put these under the fittings and pulled up.

They engaged the retainer rings surprisingly well.

Thanks to the other threads on here that showed the construction of the fittings as it's impossible to see under there.


The fittings are like the push-on plastic fittings sold at hardware stores.

Another set of eyes is always helpful. I'll check the relatively dimmer bulbs. May be insightful to use the DC amp meter and see what is drawn.

Thanks for the reply.

Wrapping this topic up So my hose was short and cracked at the end. I cut back to good hose. Then I cut off a couple inches to attach to the canister and I spliced in a hard or plastic tube as an extension. So far so good. Also learned about the valve at the end of this hose and researching on here ...

Now this officially sucks!...the glove! Success! Now for a test drive Something I realized there are many failed glove glove test videos and not too many passing videos. Before I knew what to look for I thought my glove test was ok since it didn't "blow up like a balloon animal". Since my ...

It is not a 100% foolproof fix. Also it assumes it is not a faulty ABS sensor or reluctor ring that the sensor uses on the axles. There are resistance values for the ABS sensors so worth checking those out. I think Mid-West ABS has a trouble shooting section on what the values should be. Neil. SUPE...