Oil galley brushes, Marval Mystery Oil, some people add Simple Green to the oil. Whatever you do, change the oil as soon as you get the passages unclogged.

Check the Fuel pressure regulator ... on the '96 960 it should be below the fuel rail.

Woah woah woah! .... '94 850 NA have a Flame trap that needs periodic cleaning or replacement. It located on the side of the intake hose, the larger hose runs to the oil trap. Check the Flame Trap and see if it clogged up. New ones are about $5.00.

You might try disconnecting sensors in the lists below and see if the DCTs change. -------------------------------------------------------------- EFI-444 Accelerometer. Signal too high. Permanent fault Diagnostic trouble code (DTC) information EFI-444 A2300538 Condition If the engine control module ...

Only three things it could be ... Fan Control Module, Climate Control Module (CCM) or wiring from FCM to CCM.

From what I gather the codes represent a camshaft position sensor circuit fault on the intake cam. When I measure the harness, with the CPS disconnected I get 5V on red/#1, Ground on black/#2 and 0.96V on blue/#3. 2.5V - 5V on blue with the CPS connected. Blue is the CPS output, It is not going to ...

Tonight I tested Vida 2014D RePack on a machine which has Windows 10 Home. I installed 2014D RePack per my instruction, posted Feb 19 2018, 13:21. Vida 2014D RePack installed and ran on Windows 10 Home without any modifications. So far I have confirmed Vida 2014D RePack installs and runs on Windows ...

P0340 ECM-3000 Camshaft position (CMP) sensor, intake Faulty signal or signal missing P0347 ECM-3010 Camshaft position (CMP) sensor, exhaust Signal too low P0348 ECM-3010 Camshaft position (CMP) sensor, exhaust Signal too high Dead battery could be the reason for the switch from P0348 to P0347. Both...

P0340 ECM-3000 Camshaft position (CMP) sensor, intake Faulty signal or signal missing P0344 ECM-3000 Camshaft position (CMP) sensor, intake Faulty signal or signal missing P0342 ECM-3000 Camshaft position (CMP) sensor, intake Signal too low. Intermittent fault P0342 ECM-3000 Camshaft position (CMP) ...