Search found 859 matches
- 03 Mar 2021, 00:15
- Jump to forum
- Jump to topic
Re: Red Battery light came on today
I think its an intermittent issue, as I said the first time I checked it with a voltmeter running it was only at 12 V ( battery voltage) so nothing coming from the alternator. I'll see what tomorrow brings and report back! Have you cleaned the battery terminals and the B+ wire connectors? It would ...
- 05 Mar 2021, 18:47
- Jump to forum
- Jump to topic
Re: what is that?
Super rare third row Armrest.
- 05 Mar 2021, 20:54
- Jump to forum
- Jump to topic
Re: 4C Misery -2006 V70R AWD Auto
I’ve always wondered what these things do electrically, change valving ? Yes with the Monroe 4C, valves to restrict the fluid flow therefore changing the damping. Some other makes do it by applying a voltage across a special fluid. The voltage changes the viscosity of the fluid therefore changing t...
- 06 Mar 2021, 19:05
- Jump to forum
- Jump to topic
- 07 Mar 2021, 15:11
- Jump to forum
- Jump to topic
Re: 2004 S60R B8444S (V8) conversion (Previously : Exhaust Manifold removal.)
Cameron Pyzewski"s B8444S swap.
- 15 Mar 2021, 03:48
- Jump to forum
- Jump to topic
Re: Fluids disposal questions
Where am I suppose to dump this stuff properly? Separate it first. 1. Pour the mix in s 5 gallon bucket and let it sit for weeks with the lid on. ( Water being heavier will sink to the bottom ). 2. Place a shim under one side of the bucket. 3. On the other side of the bucket, poke a hole near the b...
- 22 Mar 2021, 14:51
- Jump to forum
- Jump to topic
Re: an after the fact question about disconnecting the battery
.
Not as good.
1. Does not shut down the REM.
2. The correct order is:
Not as good.
1. Does not shut down the REM.
2. The correct order is:
- A. Disconnect negative terminal.
B. Disconnect positive terminal.
C. Reconnect positive terminal.
D. Turn key to POSII.
E. Reconnect negative terminal.
- 24 Mar 2021, 21:23
- Jump to forum
- Jump to topic
- 27 Mar 2021, 11:18
- Jump to forum
- Jump to topic
Re: Stalling at idle when warm P0102
Checked all the usual things and cleaned the MAF with sensor cleaner. Possible source Flow too high: short-circuit to supply voltage in the signal cable open-circuit in the ground lead defective sensor Flow too low: Air leakage contact resistance Contaminated throttle body (TB). short-circuit to gr...






