RickHaleParker wrote: 28 Jul 2021, 23:35

chrisjack wrote: 27 Jul 2021, 21:38 So the one I have is defective.

Don't toss it in the trash. The case and cords could be used to house a CEM cracker.

Good tip, I was thinking about junking it . Thanks RickHaleParker

These settings vary by market so you might not have the options in vida available in your car in NZ.


Yeah; quite possible. The car I have is imported from the Japanese market; having DRL's is not mandatory in NZ. However, what I am curious to understand is; are there any members who have the ...

I have been playing around with three light options in VIDA. Currently my option is set to the following:

Flexstd and DRL activated by sensor.

During the day I have no DRL and the BI-Xenons are off as well. The light knob position is 0. Turning the knob to position 12 or 1 turns on the Bi-xenons ...

I have been playing around with three light options in VIDA. Currently my option is set to the following:

Flexstd and DRL activated by sensor.

During the day I have no DRL and the BI-Xenons are off as well. The light knob position is 0. Turning the knob to position 12 or 1 turns on the Bi-xenons ...

Update: Managed to borrow a DICE unit which works just fine. So the one I have is defective.

So I've had a look at the CEM and it's in a good condition, no water damage. Cleaned the connectors and put it back. No luck, still the same issue.

I might just leave it as I'm not sure about what else could be done.

Thanks Roger_850T, that makes sense. I will be disconnecting the CEM to have a look at the condition. I will post an update once I am done with it.

It scanned through and gave a pass result on all modules; so I'm wondering if the comms link to the rest of the modules is via CEM; how is a third party scanner able to establish a link and VIDA via DICE is unable to achieve the same?

Are you sure you are interpreting the Maxidiag MD806 pro ...

Pull the CEM out and check for water damage. Clean all the electrical connectors and reinstall.


Thanks for the reply @RickHaleParker. I will make some time to do the visual checks.
A noob question though: I used an Autel scanner (Maxdiag MD 806 pro) which I have used/borrowed in the past to see ...

Hi to all people on this site. This is my first post and first attempt to use Dice.

Background: I've got a DICE unit off eBay and the tests for DICE diagnostic passes. Installation of VIDA has been all good. Reading car Vin and details works fine.

Issue: When I go over to the Vida diagnostic tab ...