May be a long shot but check ground wire to fuel pump

Hi all
I have a 2003 xc70 420,000 miles,
Coming home after work I experienced a loss of power made it home scanner says misfire cylinder 2
I moved coil packs and plugs no change then tested fuel pressure then to compression. Well 1,3,4,5 had 155 to 160. #2 almost none put some oil in and came up to ...

Good afternoon,
I have a 2003 xc70 I recently replaced the heater core and yes I broke the heat blend door link arm.
Any suggestions on how to replace it
Tips and tricks also should the HVAC system be in a specific mode when I attach the actuator
Thanks again
P

Morning All
I have a 2003 xc70 has developed a coolant leak. I wanted to isolate the heater core. Can I put hose clamp pliers on both hoses and still use the car ?
Thanks P

Morning,
I have a 2006 s60 about 150,000 miles a day ago driving around and a loud clunk from the transmission with a shutter that shook the car then the vehicle coasted to a stop. It starts and engine runs fine only get loud clicking as I shift through the gears when I put it back in park sounds ...

Hi all
I have a 2003 xc70
It has an intermittent no start with ecm 5200.
When I crank it no rpm registering on dim.
This morning it decided to start seems to run fine.
1. Years ago I replaced the Crankshaft position sensor of course the brack broke also the connector.
After the repair I would get a ...

Has anyone tried foxwell scanner?
Thanks

Good afternoon.
My xc70 has developed an oil leak just at the turbo drain connection at the base of the turbo housing. Other than taking the awd chunk out are there any other methods to stopping the leaking. At least that is where I believe the leak is located.
Thank
P

Good afternoon.
My xc70 has developed an oil leak just at the turbo drain connection at the base of the turbo housing. Other than taking the awd chunk out are there any other methods to stopping the leaking. At least that is where I believe the leak is located.
Thank
P

Hi all
Thanks for the Ideas, for now it seems cleaning and replacing fuses as suggested is working I have driven several hundred miles without any issues.
Thanks again