Wheel bearing Hub puller

Post by **abscate** » 23 May 2019, 20:12

You don’t pull the front wheel bearing off the hub.

Post by **vtl** » 24 May 2019, 06:53

Mr. Detail wrote: ↑23 May 2019, 06:28 Thank you all. " oragex" I planned to replace the whole hub with bearing included. About $75 new. With that said do I still need the puller?

I replaced similar one (Optima?) in the donor chassis I got recently. It barely did 20-30k miles. Buy Volvo or FAG.

tardcart · Post by **tardcart** » 24 May 2019, 07:25

abscate wrote: ↑23 May 2019, 20:12 You don’t pull the front wheel bearing off the hub.

people are getting mixed up, the original question is if he needs a puller to get the hub assembly out of the knuckle. Often they are rusted in place and have to be beaten out (discard) or use a slide hammer. Use a three jaw to push back the axel if rusted In the hub as suggested.
do not keep screwing the puller against the axel to remove the hub as the transmission or axle will be damaged possibly. from large side load not designed to resist.

Post by **cn90** » 24 May 2019, 21:56

I don't get mixed up.

Once the 4 bolts holding the bearing are removed, it is just a matter of some hammering, it will come out.

Wheel bearing Hub puller

Re: Wheel bearing Hub puller