P0600 code,rough idle, noise at ecm
1999 V70xc was running fine and upon starting after 4 days sitting got rough idle, p0600,p1633,p0460 codes. ECM was redone by Xmodex about 15k ago and ABS redone prior to that.After turning off and removing key ecm whines for while.Any suggestions? Chasing wires presently trying to rule out shorts.
-
RickHaleParker
- Posts: 7195
- Joined: 25 May 2015, 14:30
- Year and Model: See Signature below.
- Location: Kansas
- Has thanked: 8 times
- Been thanked: 977 times
P0600 is a ECM communication error. Sometimes pulling the ECM cleaning the contacts and reseating the ECM does the trick.
P1633 is just saying there is a error code stored in the ABS. You need a scantool that can access the ABS.
P0460 I think this is a poor translation. P0460 is not listed for the '99 70XC. The standardized translation for P0460 is Fuel level sensor signal.
P1633 is just saying there is a error code stored in the ABS. You need a scantool that can access the ABS.
P0460 I think this is a poor translation. P0460 is not listed for the '99 70XC. The standardized translation for P0460 is Fuel level sensor signal.
Active
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )
-
abscate
- MVS Moderator
- Posts: 36137
- Joined: 17 Feb 2013, 17:54
- Year and Model: 99: V70s S70s,05 V70
- Location: Port Jefferson Long Island NY
- Has thanked: 1609 times
- Been thanked: 4064 times
Pull the connector of the ETM and make sure that’s the source of the after key whine. There are a couple of things that whine on shutdown, the ETM isn’t one of them.
Empty Nester
A Captain in a Sea of Estrogen
1999-V70-T5M56 2005-V70-M56 1999-S70 VW T4 XC90-in-Red
Link to Maintenance record thread
A Captain in a Sea of Estrogen
1999-V70-T5M56 2005-V70-M56 1999-S70 VW T4 XC90-in-Red
Link to Maintenance record thread
-
- Similar Topics
- Replies
- Views
- Last post