Engine mounts and replacement!

niall · Post by **niall** » 26 Mar 2009, 16:29

Got it done today.
Took some experimentation, but once it was setup, it was a breeze.

Post by **tailor** » 26 Mar 2009, 22:10

Niall , great job, it looks like the 1/4 inch flat bar as a washer worked really well.

niall · Post by **niall** » 27 Mar 2009, 18:48

The flat steel bars came from leftovers from a broken garage door opener...sometimes it pays to keep junk lying around!

Note the threaded bar extends more on the right side of the bushing.
This was a helpful tool in keeping the bushing centered as it went in..

Niall

alexk243 · Post by **alexk243** » 04 Dec 2012, 13:54

Here is my version of replacing the mount using old snowmobile bogie wheels: