More statistics on US states and COVID-19 growth rates. My raw information is from Worldometer. Any errors or misrepresentations are my own. I have reviewed all US states for the COVID-19 statistics. I have color coded the results. This data is for June 12, 2020. Results may change over time. First...

Got the Delrin bushings installed into the T5's subframe, while prepping for the manual install. https://turbochuckcom.ipage.com/webimages/projects/97%20Volvo%20854T5/2020/Manual%20Swap/bushin_2.jpg Oooh yeah, delrin is the way to go! Chuck - Do those get pressed into the frame ? Some lube and a de...

I used a 1# sledge to knock 2 of them out. The other two required 20 seconds with a recip saw to cut part of the way through the plastic outer cup (stuck the saw in the gap in the bushing and cut from the inside, out. Not all the way through the shell), then whacked them out with a hammer. You can h...

You can also get creative and do metal embossing by making a male die and a rubber pad to press the die against. 20 tons should work for patterns a couple inches across. I saw a car magazine article where they made a jeep logo this way.

volvolugnut

Driver's side, under the dash, access from beneath.

viewtopic.php?t=69527

Racism and tribalism and them-and-us and "others" begin very early. I believe they are mostly a learned behavior. The motive behind all forms of discrimination is the same. People or incorporated persons trying to get something without having earned it. If one does not let themselves get ...

scot850 wrote: ↑28 Jun 2020, 15:03 ... said they were much better than P80 versions.

Neil.

BLASPHEMY! Nothing is better than P80. Period!

And I'm white. Every person on the planet get their skin color from the same pigment Melanin. Same pigment same color. The difference is the density of the Melanin. Same pigment, different densities = We are all different shades of the same color. If you think you are white hold a piece of paper ne...

I have read that if the PTC port gets clogged up, then that can also cause the glove to inflate. If you haven't done it already, it might be a good idea to pull the PTC and check to see if it's clean.

If you are replacing a valve because it started to burn or chip, then it should be straightforward, If you are changing valves because they hit pistons and bent, or with excessive miles, check the stems/guides.( How much do the valves wiggle) with the springs removed and cleaned.