I pull the red tab loose or out and then reach through the metal cutout hole to push the latching hook down. That piece of plastic on the outside of the speaker is almost useless for getting the hook on the other side of the speaker to move. You just have to feel where to push while reaching through...

Thank you for the information! I am ordering the 240 grit Flex-Hone and will report back the results. I forgot to write that I searched through VIDA for this info on all the available 5-cylinder Volvos in the 2014 release. I am surprised the engine information for bearing and piston sizes are stampe...

The P2 Volvos have the EPA mandated fuel system leak detection and Onboard Refuelling Vapor Recovery (ORVR). P80 vehicles didn't have either of these systems. The company I used to work for supplied the vapor vent valves for the stainless steel Volvo fuel tank version that was used to pass the Calif...

That is an activated carbon filter for catching hydrocarbons from the intake manifold trying to escape and cause an evaporative emissions test failure on PZEV certified Volvos. It helped the entire vehicle pass the very strict PZEV SHED emissions testing. The last squirts of fuel from the fuel injec...

Cutting fuel system access holes is a risky modification. Some fuel tanks used to be located inside the trunk area of cars (Mustang, Jaguar, Mercedes) and during extremely strong rear impacts, the fuel tank would be crushed and spray the interior of the vehicle. Many car companies run a non-regulato...

2007s have the paint code on a sticker near the hinges on the rear door frame. there are stickers on both sides and I can't remember which side has the paint code.

This usually works for my 2001 V70s: 2001 Volvo S80 / V70 / S60 Models • The service reminder indicator lamp illuminates for 120 seconds when the ignition is first switched on. • Insert key and turn Ignition Switch to position I • Press and hold in the reset button for the trip odometer • Turn the I...

The plastic covers come off the top of the back seat but it is very easy to crack and damage these covers. Once the end covers have been removed, you will be able to see the seat belt spools and blow them clean with compressed air. I tried to find instructions and pictures in Vida/Dice and found not...

AI chat robot???

I have removed the #13 steering shaft by hitting it from under the car with a long shaft pressing on the bottom of the flange with bolt #15 completely removed. After enough pounding the shaft just pops off. Always use plenty of anti-seize on the replacement parts because of the dissimilar materials ...