Looking at the Video I think you need https://www.freel2.com/gallery/albums/userpics/13868/LR005564.jpg Take a look at this post for the first cousin with the same 3.2 as yours https://www.freel2.com/forum/topic38639.html If you don't mind the part coming in a LAND ROVER box then get this LR005564 -...

MVS Readers, It has been 4 years since I started this thread and My Son (the one I bought the S80 for) has decided to move on from Volvo. He did buy a car made in America at a factory very close to my house in San Jose, and we picked it up at the factory in Fremont. So this seems like the right tim...

Madbadger, The Volvo S80 and the Land Rover LR2 share a lot in common and I own one of each. From the Land Rover enthusiast if the steering column lock doesn't release when you dock the key then you can't move to the next step. This is a common fault on the LR2 but I believe that you are getting pas...

The Latch for the electrical connection is easily damaged so be careful.

The Sensor is difficult to press in and rotate

https://www.freel2.com/forum/topic29608.html

viewtopic.php?f=9&t=91975&p=525023&hili ... 15#p525023


Good luck

Paul

Yes you can use those FK20HQR10 is a Twin Tip Denso Iridium Plug It is very similar to the 4704 IKH20TT The difference is that the VOLVO Plug is a Super Ignition Plug and it has a slightly larger diameter for the Iridium Tip 0.55 mm vs 0.40 mm I would happily use these in my 3.2 Here is a JPEG that...

Land Rover has a rebuild kit. You are asking about the last item on the list. (I don't know the VOLVO part number) Outer pinion bearing - Timken 30206 Inner pinion bearing - Timken HM88649/HM88610 (Optional) Collapsible spacer - LR023443 Retainer nut - LR050541 Pinion shaft seal - LR023442 Output sh...

Can you specify which engine you have? I am going to assume a 3.2 6 cylinder Gasoline powered engine. For the 3.2 the PCV routes the vapors (and oil if its not working) to cylinder 6 first then 5, 4, 3, 2, 1 I would look at the PCV for a 6, 5, 4, misfire. Get the aftermarket part marked with FoMoCo ...

Legger, Based on my experience your valve is starting to fail. The next time that you change the oil and filter you should inspect the small rubber disc. For a new valve I would expect the following (based on my experience with two Volvo Si6 Engines) --- 3 to 4 minutes after shutdown and the oil lev...

For my 2010 S80 3.2 I replaced the fan with an aftermarket continental unit and it works well. When I bought it it came with the controller but I believe that is no longer the case. I did shim the fan slightly so that it wouldn't rub. Note: if I didn't do this the plastic would have worn in eventual...

The Chart shows what is needed - The Engine is cold - Turn it on and run at idle with defroster and AC on for 2.5 minutes - Accelerate using 1/2 throttle to 55 mph - maintain 55 mph for 3 minutes - Slow to 20 mph ( do not brake!!! ) - accelerate to 60 mph using 3/4 throttle - maintain 60 mph for 5 m...