any resolutions for this one? currently experiencing the same problem.. the ink pen does not work..

The blower motor resistor (or power stage in the case of the ECC) is inset into the air duct directly to the right of the relay(s) that are shown in MIJ's picture. With the ECC there is only the A/C relay, on the MCC there is the A/C relay and the max speed fan relay. ...Lee Hello there mod, I just...

Hi jabblackburn,See my earlier post first please.Today i retested my figures and i may have tested the Checking Signal cable to Ground, wrongly.In the test proceedure it askes if the resistance is infinate and it isent.I get a reading of 1.43 Kohms with my multimeter set on the 20K setting.Does thi...

Sway bar links are easy for anyone with a jack, requires two bolts to be removed. If you jack your car in the centre of the sub frame(so you lift both front tires) it should put even pressure on the sway bar so you can do it with one jack. Most recommend doing both end links, as a broken one can pu...

DIY: 1998 Volvo V70 Ignition Switch & Cylinder Lock Replacement Car is 1998 Volvo V70 with 106K miles. - Symptoms: sometimes cannot crank the engine, after wiggling the key a few times, then I can start the engine. It was intermittent, then it became permanent. - Key can turn to Position I and ...

Sorry I overlooked the thread! My mistake.

Last month, my uncle visited a mechanic to test his front Coupler and bearings. He was asking for a replacement for both two because of some silly noise he was hearing. Upon the diagnosis, the mechanic found out that the problem was the drive shaft . He was advice to replace the drive shaft with a n...

92 940? You may have a problem with the rpm sensor on the flywheel. When you are r&r'n the distributor cap, you may be disturbing the lead going to it. Remove the cap, get flashlight, look straight down behind head to bellhousing. You will see a large wire coming out of bellhousing and ending u...

mrjacobrussell wrote:i could use some advise
I'm not sure what part to buy from fcp groton or if i should get the head gasket set from some where else any help would be apriciated

have you already figured out what part will you buy from fcp? Have you called them up?I also called them last week for a gasket kit.

AlanS, That is common especially if you got an aftermarket evaporator. The lines are are aluminum and you can bend them into the proper angle with your hand. It may be a bit harder to do since the evaporator is already installed because not much of the tubing is extending out of the firewall, but i...