Where to buy 40 Torx 7" extension bit (Thermostat job)?

genie · Post by **genie** » 20 Apr 2003, 12:49

Hi,

I tried to change the thermostat without the extension 40T. As expected FAILED. The local shops don't have it, that's why I didnot had it in the first place. Can anyone advise on where to buy? Thanks
Ihsan

Post by **matthew1** » 20 Apr 2003, 18:56

Did you try Sears Craftsman or your local Snap On dealer?

genie · Post by **genie** » 20 Apr 2003, 22:04

The sears didn't have it. And we don't have snap-on in state college. Only Pepboys and advance auto parts. Neither of the above had it. However, I've found an online retailer. I ordered it.
Thanks though.
ihsan

Post by **matthew1** » 21 Apr 2003, 00:16

Super, glad you found it. Wish I could give you a special hint or two, but the thermostat's so straightforward, there's nothing tricky

.

Peter00228980 · Post by **Peter00228980** » 05 Apr 2006, 23:06

You know those allen wrenches that have multiple sizes that fold from each side over each other. They make that in a torks and it was just long enough to reach the rear bolt on my thermostat. I used it to break the bolt free and then used a flat head screwdriver of proper size to back the bolt all the way out. No damage what so ever to the bolt.

Post by **MadeInJapan** » 06 Apr 2006, 05:55

AutoZone sells a kit that has long torx drivers in it. A red and black handle that each one slips into so you can get some torque on it too...a bit pricey...just under $20 for the set. It includes the T40.

Post by **robert213** » 06 Apr 2006, 13:30

My local Sears and NAPA did NOT have it. I don't have access to SNAP-ON.

Perhaps you could try Harbor Freight. I bought mine at McMaster...

http://www.mcmaster.com/
(630) 600-3600

Enter page number 2609 in search field.

http://www.mcmaster.com/ctlg/DisplCtlgP ... PgNbr=2609
3/8" Square Drive, Long
T30 5" Length 6939A84 13.84
T40 5" Length 6939A87 13.84 <--
T45 5" Length 6939A88 13.84
T50 5" Length 6939A89 13.84

My whole experience here...
http://www.volvoforums.com/m_16392

oldvolvoguy · Post by **oldvolvoguy** » 29 Apr 2006, 17:45

I had the same problem with a short torx not fitting in on my 97 850. Very easy solution though at zip cost. Start car, remove fuel pump fuse under hood and let the car run out of fuel. Then, using the correct flare nut wrench, remove the fuel line that is actually in the way of the torx nut and then you have the access you need. Job done and no futzing around. BTW thin wrenches work better in this slightly confined area than a thick Craftsman.

cocka · Post by **cocka** » 29 Apr 2006, 22:30

Heaps on Ebay, usually as sets though !!!

Post by **matthew1** » 29 Apr 2013, 19:19

According to Robert J who left a message on the Replace Thermostat DIY page, the Snap On T40 Torx extra long bit did it. Part number FTXEL40E2, here -> http://buy1.snapon.com/catalog/parts/pr ... _id=683308

$10