just did a simple mod and WOW!

[trophytaker308]

well if i did it wrong it would of not line back up properly like it showed me in the vid,right???

[jblackburn]

What the crap?

2-3 turns at MOST.

You're going to blow up your engine. 10+ PSI at 2000 RPM will bend rods.

[s70glt novice[Will]]

what you did, im assuming, was turn it by hand and pull it out to fit over the wastegate. its not actually set at that psi, but is being forced to.

[s70glt novice[Will]]

the best thing to do is to get the wastegate tool, and adjust it with that. Adjust to stock settings, drive it for a bit and see if you like it. if not, you can do 1-2 turns MAX.

[Matty Moo]

Bad idea doing it blindly without checking wastegate pressure and without a boost gauge.

The amount of boost isn't the issue, it's the fact that it's coming on so early. That's what bends rods.

[trophytaker308]

What the crap?

2-3 turns at MOST.

You're going to blow up your engine. 10+ PSI at 2000 RPM will bend rods.

wow i was at 4 or more...lol grang ,should i not be in the half way mark in my white line,is that 2 much....did lucky have a different motor i wonder???

[trophytaker308]

well if i did it wrong it would of not line back up properly like it showed me in the vid,right???

no i did not pull it back to fit,i turned it back so it would fit like he said.

[s70glt novice[Will]]

No, i think your problem of not building boost was coming from something else... investigate further. Have you done your vacuum lines?

well if i did it wrong it would of not line back up properly like it showed me in the vid,right???

no i did not pull it back to fit,i turned it back so it would fit like he said.

Did you use the ipd wastegate tool? or twist it and pull it on?

[trophytaker308]

all my vacumes ar fine,no leaks,and yes i used a tool from a friend at fast trax race shop.

[s70glt novice[Will]]

okay... that makes more sense... what psi on the tool did you set it too? I believe stock is around 3.5? That may be for just the newer s70s