engine mount: does the bushing thread...

Post by **xHeart** » 15 Jun 2012, 15:39

The recipe worked, but there is a problem.
The ring holding the bushing has move 1/8 in right. Do I pull the ring back, would it?

: the ring holding the bushing has shifted; MVS_4461.jpg (310.94 KiB) Viewed 938 times

Post by **xHeart** » 15 Jun 2012, 15:44

It is pulled over a bit, not centered.

: view from driver side; MVS_4458.jpg (458.62 KiB) Viewed 937 times

Flush with the holding ring, little bruised.

: view from passenger side; MVS_4460.jpg (490.46 KiB) Viewed 937 times

Should I try to center it, would it?

Post by **MoVolvos** » 15 Jun 2012, 16:03

-
Try attaching the upper firewall mount first and see how it fits in relation to this one before deciding what to do. The unit is for fore and aft movement so the side to side position should not make a whole lot of difference unless it is really off. As it is the mount is not intended to support the weight of the engine but to control movement and vibration.

Blessings,
BKM
-

Post by **xHeart** » 16 Jun 2012, 11:51

It drives much better after replacing the two mounts.
But didn't want to not adjust the placement of ring, and busing.
Some modification which helped to restore.

: using high school carpentry lessons; MVS_4462.jpg (402.54 KiB) Viewed 908 times

An acceptable completion.

: 98% back to factory placement - centered.; MVS_4463.jpg (440.68 KiB) Viewed 908 times

Thank you so much MVS!