Another issue seal leaking :/

billybobo · Post by **billybobo** » 14 Jul 2013, 16:40

i cant figure out which seal/seals i need...

: trans exploded view.PNG (284.74 KiB) Viewed 721 times

Its leaking from where the screw driver is sitting. in between the axle shaft and the transfer case spline sleeve.

Post by **jimmy57** » 14 Jul 2013, 18:00

There is no seal there. if fluid level is high enough, like when engine has been off for a while and torque converter drains back into sump, then fluid is high enough to come out there.
The cup you put back in place may stop fluid from the bore inside splines but the axle gear the axle inserts into inside diff unit but the axle gear is not sealed to the diff case inside diff.

billybobo · Post by **billybobo** » 14 Jul 2013, 18:17

So is it normal for fluid to come out of there after refilling it? What keeps the fluid from coming out there?

Post by **jimmy57** » 14 Jul 2013, 18:23

The seal on the end of the angle gear where axle inserts.

billybobo · Post by **billybobo** » 14 Jul 2013, 18:40

Ooohhh I c now.

15??

: image.jpg (61.36 KiB) Viewed 707 times

billybobo · Post by **billybobo** » 16 Jul 2013, 15:03

jimmy57 wrote:There is no seal there. if fluid level is high enough, like when engine has been off for a while and torque converter drains back into sump, then fluid is high enough to come out there.
The cup you put back in place may stop fluid from the bore inside splines but the axle gear the axle inserts into inside diff unit but the axle gear is not sealed to the diff case inside diff.

number 46 goes there...There is a seal there.

it would make no sense to seal everything up besides that.

i knew something had to go there.