Login Register

Volvo Cable connector

A mid-size luxury crossover SUV, the Volvo XC90 made its debut in 2002 at the Detroit Motor Show. Recognized for its safety, practicality, and comfort, the XC90 is a popular vehicle around the world. The XC90 proved to be very popular, and very good for Volvo's sales numbers, since its introduction in model year 2003 (North America). P2 platform.
Post Reply
akace123
Posts: 4
Joined: 30 December 2019
Year and Model: XC90
Location: London

Volvo Cable connector

Post by akace123 »

Hello All

Can someone please tell me what this connector is.

I am looking for this in a Male to female as I need to extend this cable.

Photo attached

Thank you and Happy New Year Volvo People Around the World
Attachments
index.jpg
index.jpg (26.2 KiB) Viewed 609 times

User avatar
SuperHerman
Posts: 1798
Joined: 1 December 2014
Year and Model: 2004 & 2016 XC90
Location: Minnesota
Been thanked: 207 times

Post by SuperHerman »

Where did the cable come from? What device, module ... are you extending?

User avatar
Rattnalle
Posts: 1674
Joined: 1 September 2017
Year and Model: 2004 V70 2.5T
Location: Sweden
Has thanked: 20 times
Been thanked: 133 times

Post by Rattnalle »

Looks like the P2 CAN network connector.

akace123
Posts: 4
Joined: 30 December 2019
Year and Model: XC90
Location: London

Post by akace123 »

Its a connector from the massage button cable and needs to extended to the cable where it fits into the seat, its like 3 to 4 cm short so if i can find extender cable it would be great

akace123
Posts: 4
Joined: 30 December 2019
Year and Model: XC90
Location: London

Post by akace123 »

SuperHerman wrote: 30 Dec 2019, 15:39 Where did the cable come from? What device, module ... are you extending?
Its a connector from the massage button cable and needs to extended to the cable where it fits into the seat, its like 3 to 4 cm short so if i can find extender cable it would be great

akace123
Posts: 4
Joined: 30 December 2019
Year and Model: XC90
Location: London

Post by akace123 »

Rattnalle wrote: 30 Dec 2019, 15:40 Looks like the P2 CAN network connector.
I am not sure that helps as Igoogled that and not a lot help from Sir Google.

Can you advise a little more please

User avatar
RickHaleParker
Posts: 7129
Joined: 25 May 2015
Year and Model: See Signature below.
Location: Kansas
Has thanked: 8 times
Been thanked: 958 times

Post by RickHaleParker »

Can you reroute the cable it on a shorter path?
⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000.
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0.

User avatar
SuperHerman
Posts: 1798
Joined: 1 December 2014
Year and Model: 2004 & 2016 XC90
Location: Minnesota
Been thanked: 207 times

Post by SuperHerman »

I don't think one will find an extension cable. Most likely you can find the two connector ends and then add the wires.

Best route is what RickHaleParker suggests - second best route is to pick the end of the harness with the fewest wires and easiest access and then splice in the amount of needed wire to reach. One wire at a time so no mix up, cut, strip, solder, shrink wrap and move on. Then either shrink wrap or tape the entire repaired area and add a wire loom if wanted/needed.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post