Here's the page from VIDA that lists the torques for the axle group, I didn't find the torque for the bearing cap 2 screws that contain the bearing. If the parts are clean and well mated, the torque by bolt size will have to do. I put a drop of blue loctite on mine. 20k miles and holding. axle-t6orq...

Here is what I would do in your situation. 1. Check the pressure at the fuel rail. You can measure it independently with a pressure gauge (which is a bit challenging) or swap the sensor between two of your 3.2s. I own two 3.2s and I would swap the sensor or replace it. Why? if the sensor is measurin...

If you bought the cheap cam holding tool,throw the m6 bolts in bottom of the nearest lake. Get some real ones from Belmetric. This saves us hearing you whine about snapping them off in the back of your cam and having to take your engine head cover off Yes, the more expensive one is less than the che...

I'm aware. Sometimes they list parts in VERY weird categories. All the decoupling pulley bits are listed as transmission parts?? https://usparts.volvocars.com/a/Volvo_2009_XC90-32l-6-cylinder/_51507_5832313/Transmission/GR-376577.html?assemblySearchGuid=16494F94-8C91-48CA-8D42-83D352775D1A Anyhow, I...

I had the Check Brake Lamp error on my 2003 XC-90. It started out intermittent but progressed to permanent failure. Third-eye brake lights works, but other two do not I accessed the REM (rear electronic module) behind the left cargo panel. Replaced the relay switch that feeds the brake lights. On my...

ChitownV makes a very good point. The original Sparkplugs were likely sourced from more than one vendor. Looking at the pictures above you have the following information on your old sparkplugs - Made in Japan - ILFR6B Those are NGK Sparkplugs I prefer the Denso Iridium TT but I don't have any data ...

+1 on Walmart for the battery as their warranty is decent and their stores are everywhere. On my kids 2005 I found it could take two sizes (H6 and H8 if I recall right) so went with the larger one. For trim I’d anticipate any standard polish should work. If needing completely re-done could be painte...

First: ChitownV is giving you excellent advice..........continue to follow that advice If I was fixing this XC90 I would do the following 1) Verify that the PCV is working using the glove test and if I had any doubts then I would get an aftermarket PCV marked with FOMOCO 2) Get a set of Denso Iridi...

The photo above from 2019 is still fresh in my memory. Live and learn; preparing for every thing that could... here is the full saga viewtopic.php?t=91484

. The XC90 V8 is on my Volvo bucket list and maybe the last as the newer 2.0's and others have oil burning issues. Last month Member chitownV went and looked at a V8 for me as he was 20 minutes and I 4 plus hours away from the dealership. He is very knowledgeable of the XC90 and very helpful to say ...