can you calibrate or check the accuracy of the instr panel readout for approx miles left before gas tank empty? mine seems to not be accurate anymore. thanks

just redid crankcase vent pipes. in the process you have to remove the fuel injectors, intake manifold, throttle housing with associated vacuum hoses and a few other small items. while there i went ahead and cleaned a really dirty throttle plate and replaced the corroded distr cap and rotor button. ...

this may be redundant with an earlier post i sent but it's getting weirder and more frustrating as i go. i set out to only replace the crankcase vent pipes because they may be stopped up. but while in there doing that i found a very corroded rotor button and distr cap, extremely dirty throttle plate...

just cleaned a FILTHY throttle body and plate. can't believe the car would even run but it did. now it idles with a slight lope and the check engine light is on! do i need to reset the throttle position by "clicking" the position box to make the light go off? it idled better dirty. have re...

here's another issue there seems to be differing opinions on. what is the correct cleaner for a turbo throttle body and associated parts like idle motors? some say brake cleaner, some carb cleaner and some special throttle body cleaner only. some don't have chlorine in them. what melts what? what ru...

just redid my vent pipes on the 850. one of the 1/2 inch pipes coming off of the oil separator box that goes 90 degrees around the distributor end terminates into the large fresh air intake pipe at the firewall. there is a small apparatus where it ends with a rubber boot that has an electrical conne...

got some info on cleaning the throttle plate when i check the crankcase ventilation system. instructions are a bit sketchy. exactly where is the thr plate location? how much stuff do you have to pull off?

after 3 tries it still leaks. tried with sealant, without sealant, cork and rubber. tight bolts and looser bolts. never experienced anything so simple yet so difficult. i cannot find torque specs anywhere for these 14 small ten mm bolts. anybody know the torque or have an technical suggestions? thanks

did a search and found a guy with a similar problem. he replaced the mast. but somewhere i read that when an antenna won't telescope properly it's just a small wheel inside the unit. anybody ever heard of that and what is the wheel called? thanks

had a bad trans pan leak. did a meticulous job of inst another gasket. still have a very slight leak. can there be another spot on the trans body where it could still leak? like around linkage or another gasket. also does anyone know of a better hi temp sealant than rtv. it seems to take a set too q...