Did this almost 5 years ago when 1clip broke and it still hold, may be will last for a longest time, hope this helps…

Did this almost 5 years ago when one clip broke and it still holds, hope this helps…

Thanks abscate and Ryann for complement , the junkyard near where I live was asking for $300.00 (subframe and 2 upper arms only, California everything more expensive )plus taxes 10.50%, $50.00 warranty, $30.00 core, end up more than $400.00 ,that why I choose to do it my self...thanks

Hello, almost 2years ago when my 07 v70 2.5t was hit by a drunk driver while parked at the curb, rear left door caved in and flat tire, toe in approximately10degrees IMG_1700.jpeg .installed the doughnut wheel on and eyeballing rear wheel alignment. Next day removed the wheel and inspected the suspe...

Oh one more thing came to mind,check the passenger side drive shaft and see if the piece #3 that hold the shaft bearing #1 to the engine block still intact with no missing any bolt #4,#5&#6...and good luck .

I believed this bolt came off from the front A arm front bushing bolt #33 which attach A arm to subframe but I could be wrong...

HI,the small evaporate leak usually cause by the evaporate tube end which is connected to evaporate shut off valve cracked and/or the valve itself is broke,it is locate at upper left corner of radiator fan shroud ( driver side).Hopes this help...

You go and take a look under the hood,there is a fuses box sit right behind air filter housing box,open it up and check the fuse #2 15amps which is for controling both low beams and see if it is blown out if yes then it is the problem that you don't have low beam, I used to have that fuse blown out ...

Over a month ago after rain I had the droplets inside the headlight too. So first I used compress air to blow away any loose dirt out from the top side groove where the glass lens and plastic housing join, I spray the adhesive glue which I got from Homedepot to seal the leak,then I remove the cap be...

image.jpeg This is how I did to mine back in 2012.after researched and study,I came up with this,I got 2 PCV Valve Elbows from local auto parts store,then I lubed outside small side of elbow to make it easier to connect small end to the big end to make it look like U shape.Put the car on jack stand...